NOC:Plastic Working of Metallic Materials

Lecture 1 - Introduction to Plastic Working of Metals

Lecture 2 - Uniaxial Tension Test Analysis

Lecture 3 - Temperature effects in metal forming

Lecture 4 - Friction and Lubrication

Lecture 5 - Friction and Lubrication (Continued...)

Lecture 6 - Deformation zone + worked examples

Lecture 7 - Stresses at point and Theory of Plasticity

Lecture 8 - Slab Analysis

Lecture 9 - Slip Line Field Theory - Part 1

Lecture 10 - Slip Line Field Theory - Part 2

Lecture 11 - Upper Bound Theorem

Lecture 12 - Plasticity equations

Lecture 13 - Forging

Lecture 14 - Analysis of Forging

Lecture 15 - Analysis of Forging (Continued...)

Lecture 16 - Forging Die Design consideration

Lecture 17 - Forging Load

Lecture 18 - Rolling of Metals

Lecture 19 - Analysis of Rolling

Lecture 20 - Analysis of Rolling (Continued...)

Lecture 21 - Strain rate in the deformation zone

Lecture 22 - Rolling mills

Lecture 23 - Prblem on rolling

Lecture 24 - Drawing of Rods, Wires and Tubes

Lecture 25 - Drawing of Rods, Wires and Tubes (Continued...)

Lecture 26 - Analysis of Wire Drawing

Lecture 27 - Wire Drawing: Tutorial Problems

Lecture 28 - Extrusion Process

Lecture 29 - Analysis of Extrusion

Lecture 30 - Introduction

Lecture 31 - Sheet deformation process

Lecture 32 - Deformation of sheet in plane stress

Lecture 33 - Analysis of stamping

Lecture 34 - Instability in sheet metal forming

Lecture 35 - Deep drawing

Lecture 36 - Hydroforming